web page hit counter

How To Drain An Above Ground Pool With A Sand Filter


How To Drain An Above Ground Pool With A Sand Filter
How To Drain An Above Ground Pool With A Sand Filter

How To Drain An Above Ground Pool With A Sand Filter. Later place back the pump basket to its correct place. Take the collar off the base of the multiport valve.

How To Drain An Above Ground Pool With A Sand FilterHow To Drain An Above Ground Pool With A Sand Filter
InGround Swimming Pool 24" Sand Filter System with 2 Speed 1 HP Pump from www.walmart.com

I had a drip because sand was in the threads (check cap and filter threads) and it wasn't screwing in far enough for that o ring to seal completely. Insert the outgoing water supply line hose into the bottom hole of the container. If you have one then connect it to the dedicated vacuuming inlet at the side of the pool.

If You’re Using A Submersible Pump, Make Sure That The Outlet Hose Is Placed Into A Large Container Or The Ground So That The Water Can Be Safely Drained Away.

Use a screwdriver to loosen the bolts on either side of the collar until you can remove them completely. This is another measure to ensure bacteria don’t make themselves at home on your above ground swimming pool pump. Leave it like this for 8 hours if possible.

More here  Starting Out With C++ From Control Structures To Objects 9Th Edition Solutions

After A Backwash And Rinse, Place The Valve To The “Winterize” Setting On The Top Mount Valve.

If you have one then connect it to the dedicated vacuuming inlet at the side of the pool. I'll show you where all of the hoses connect and where the go on your pool.disclaimer. After you backwash, move the valve to the “rinse” position and let it run for 30 seconds.

Be Sure To Place Or Arrange The Outlet Hose In Such A Way That Water Goes Out (Perfectly) Without Flooding The Area And Incurring Another Damage That Would Need Professional Repair Services.

This can be done with a submersible pump, or by using a garden hose to siphon the water out of the pool. Now move the vacuum head along the bottom of the pool slowly. Thereby giving you a lot more control of how to treat and maintain your swimming pool water.

You Don't Need Thread Sealer (Tape Etc) If That O Ring Is Doing.

Later place back the pump basket to its correct place. For the full hose method, once the hose is full, you'll submerse the hose in the pool and remove the clamp or your hand from the end under the water when there is only about four feet. This involves flushing cold water through the inner part of the pipe.

Using A Skimmer Vacuum Plate.

Allow the pump to run for about two minutes to remove. The flow of the pump is 1.2k gallons per hour. If it is not already on the filter setting, push down on the handle and move it to the filter setting.

Leave a Reply

Your email address will not be published.